DISC-MDF ELEENA HAIR BOW HOLDER
$8.50 Original price was: $8.50.$2.25Current price is: $2.25.
THIS IS A PRE-CUT BLANK OF OUR OLDER DISCONTINUED MDF. Our DISC-OLD MDF LASER CUTS may have discoloration and may chip after pressing.
1 in stock
SKU: DISC-MDF-ELEENA-BOW-HANG
Category: WALL-DOOR HANGERS
Tags: BOW HANGER, BOW HOLDER, ELEENA BOW HOLDER
Description
Additional information
Reviews (0)
Description
DISC-MDF ELEENA HAIR BOW HOLDER – BLANK FOR SUBLIMATION
DISC-MDF ELEENA HAIR BOW HOLDER is approximately 13″ x 6.3″ and is 1/8 ” thick. There are 2 holes at the top for hanging and 5 holes on the bottom for hanging ribbon. Single-sided coated for sublimation, Black backside.
* Templates designs provided exclusively by TLP Bow Designs
There will be a 3.0% Handling fee added to each order.
Pressing Instructions:
- Remove the film from the white side of the substrate.
- Remove any brown residue using a soft, damp cloth with a tad bit of soap.
- Place transfer Facedown MDF face up.
- Regular press for 50 seconds @ 380 degrees medium pressure. (Time and temp may vary based on heat press)
- If using heat tape allow cooling before removing the tape.
Additional information
Weight | .5 lbs |
---|---|
Dimensions | 14 × 6 × 0.05 in |
Add a review
You must be logged in to post a review
Log In
Reviews
There are no reviews yet