MDF HAIR BOW HOLDER – BLANK FOR SUBLIMATION
MDF HAIR BOW HOLDER is approximately 12″ x 10″ and is 1/8 ” thick. There are 2 holes at the top for hanging and 2 holes on the bottom for hanging ribbon. Single-sided coated for sublimation, Raw backside.
* Templates designs provided exclusively by TLP Bow Designs
Shipping is applied at the time of purchase. There will be a 3.0% Handling fee added to each order. (Handling fee may be listed as a tax rate on checkout).
- Remove the film from the white side of the substrate.
- Remove any brown residue using a soft, damp cloth with a tad bit of soap.
- Place transfer Facedown MDF face up.
- Normal press for 50 seconds @ 380 degrees medium pressure. (Time and temp may vary based on heat press)
- If using heat tape allow to cool before removing the tape.